Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-620 Chairside
#11

Hey Tom
I've got one of those but in needs a fair amount of veneer work, mostly on the top. One of these days...
GL w/it
Terry


Messages In This Thread
Philco 37-620 Chairside - by TA Forbes - 05-02-2014, 09:20 PM
RE: Philco 37-620 Chairside - by TA Forbes - 05-02-2014, 09:22 PM
RE: Philco 37-620 Chairside - by Warren - 05-02-2014, 09:29 PM
RE: Philco 37-620 Chairside - by Ron Ramirez - 05-02-2014, 10:01 PM
RE: Philco 37-620 Chairside - by TimC - 05-02-2014, 10:02 PM
RE: Philco 37-620 Chairside - by tab10672 - 05-02-2014, 10:37 PM
RE: Philco 37-620 Chairside - by TA Forbes - 05-02-2014, 10:48 PM
RE: Philco 37-620 Chairside - by gregb - 05-02-2014, 10:57 PM
RE: Philco 37-620 Chairside - by OldRestorer - 05-03-2014, 06:36 AM
RE: Philco 37-620 Chairside - by rocklandman - 05-03-2014, 08:18 AM
RE: Philco 37-620 Chairside - by Radioroslyn - 05-04-2014, 12:40 PM
RE: Philco 37-620 Chairside - by morzh - 05-04-2014, 05:45 PM
RE: Philco 37-620 Chairside - by Giganx - 05-10-2014, 01:16 AM
RE: Philco 37-620 Chairside - by TA Forbes - 05-10-2014, 10:03 AM
RE: Philco 37-620 Chairside - by OldRestorer - 05-10-2014, 09:03 PM
RE: Philco 37-620 Chairside - by Gene Pederson - 05-14-2014, 11:24 AM
RE: Philco 37-620 Chairside - by Randy H. - 06-08-2014, 02:54 PM
RE: Philco 37-620 Chairside - by TA Forbes - 06-08-2014, 10:26 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6808 online users. [Complete List]
» 2 Member(s) | 6806 Guest(s)
AvatarAvatar

>