Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 111 Lowboy
#3

This is the one I have just finished.

Speaker: check the field coil and the transfomer.
All is done buzzing the plug: all 4 pins should show continuity to each other.

Wires under chassis: in mine the insulation is brittle, so do not bend it much.

I also had to replace the interstage transformer.


Messages In This Thread
Philco 111 Lowboy - by palegreenthumb - 05-06-2014, 06:27 PM
RE: Philco 111 Lowboy - by OldRestorer - 05-06-2014, 06:58 PM
RE: Philco 111 Lowboy - by morzh - 05-06-2014, 08:51 PM
RE: Philco 111 Lowboy - by jerryhawthorne - 05-07-2014, 04:54 PM
RE: Philco 111 Lowboy - by morzh - 05-07-2014, 06:42 PM
RE: Philco 111 Lowboy - by TA Forbes - 05-07-2014, 08:39 PM
RE: Philco 111 Lowboy - by Arran - 05-08-2014, 10:23 PM
RE: Philco 111 Lowboy - by palegreenthumb - 05-10-2014, 02:20 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4640 online users. [Complete List]
» 3 Member(s) | 4637 Guest(s)
AvatarAvatarAvatar

>