1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-690 -- silent tweeters
Texasrocker
Phorum Expert
*****
Posts: 909
Threads: 117
Joined: Jun 2007
#2

08-06-2008, 03:31 AM
Whew,Im not familiar with that model Philco. Check the schematic for your set. I remember I had the same type prob with a German made Grundig radio before. Someone doing previous repair on the grundig before, didnt use polarized type caps in the crossover between woofer & tweets, and it silenced the tweets in that set until I changed them out.
Ron or Chuck will know more than I on the Philco sets for sure. Just trying to help with suggestion. I just bet your orig tweets are still ok!?
Find
« Next Oldest | Next Newest »


Messages In This Thread
38-690 -- silent tweeters - by Guest - 08-06-2008, 01:18 AM
[No subject] - by Texasrocker - 08-06-2008, 03:31 AM
[No subject] - by Ron Ramirez - 08-06-2008, 06:46 AM
[No subject] - by Guest - 08-06-2008, 09:52 AM
[No subject] - by Guest - 08-06-2008, 11:17 PM
[No subject] - by Ron Ramirez - 08-06-2008, 11:27 PM
[No subject] - by Guest - 08-07-2008, 01:02 AM
[No subject] - by Guest - 08-07-2008, 01:56 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 4981 online users. [Complete List]
» 1 Member(s) | 4980 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration