Model 19B Completed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Model 19B Completed

PAradiogeek
Senior Member

Posts: 395
Threads: 33
Joined: Jul 2013
City: Horsham, PA

#12

05-10-2014, 04:56 PM

Morzh,

It turns out I had to take the chassis out of the cabinet much sooner than I had thought. As promised, I checked out the wires coming into the chassis from the power plug. You were right, the insulation on that wire was definitely cracked Icon_clap

I will be removing those wires tonight/tomorrow.

Thanks again for mentioning. I owe you one!
Jon

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 19B Completed - by PAradiogeek - 05-05-2014, 11:13 PM

RE: Model 19B Completed - by Warren - 05-05-2014, 11:30 PM

RE: Model 19B Completed - by OldRestorer - 05-06-2014, 06:25 AM

RE: Model 19B Completed - by Steve D - 05-06-2014, 08:17 AM

RE: Model 19B Completed - by KCMike - 05-06-2014, 09:42 AM

RE: Model 19B Completed - by morzh - 05-06-2014, 10:38 AM

RE: Model 19B Completed - by PAradiogeek - 05-06-2014, 11:05 AM

RE: Model 19B Completed - by PAradiogeek - 05-06-2014, 11:22 AM

RE: Model 19B Completed - by AJboy123 - 05-07-2014, 03:31 PM

RE: Model 19B Completed - by TA Forbes - 05-07-2014, 08:41 PM

RE: Model 19B Completed - by joybird - 05-09-2014, 07:12 PM

RE: Model 19B Completed - by PAradiogeek - 05-10-2014, 04:56 PM

RE: Model 19B Completed - by Art Hoch - 05-30-2014, 11:55 AM

RE: Model 19B Completed - by klondike98 - 05-30-2014, 12:30 PM

RE: Model 19B Completed - by PAradiogeek - 06-01-2014, 04:58 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6567 online users. [Complete List]
» 1 Member(s) | 6566 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me