Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

THE FOUR BIG ONES!
#2

Hi Sam-Great to hear you are better. I was just thinking about you and was hoping you were OK.
The 37-690 and 38-690 are great sets with their 20 tubes. I hope to eventually get the 509X going with its measly 11(I think) tubes. It was lower production and higher cost than the 690's but that may be because no one liked them when new. My best sounding radio currently is my Capehart 410H, another big fellow with 3 chassis in it.


Messages In This Thread
THE FOUR BIG ONES! - by Sam samuelian - 05-14-2014, 02:27 PM
RE: THE FOUR BIG ONES! - by y2kbruce - 05-14-2014, 02:41 PM
RE: THE FOUR BIG ONES! - by PhilcoJohn - 05-17-2014, 07:04 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 5860 online users. [Complete List]
» 2 Member(s) | 5858 Guest(s)
AvatarAvatar

>