Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38 23 philco? (bought it)
#11

Kirk, you will turn that into a real beauty I'm certain. As Ron indicated, watch out for those loose wires and hot chassis.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
38 23 philco? (bought it) - by OldRestorer - 05-14-2014, 12:51 PM
RE: 38 23 philco? - by Ron Ramirez - 05-14-2014, 02:17 PM
RE: 38 23 philco? - by OldRestorer - 05-14-2014, 02:41 PM
RE: 38 23 philco? (bought it) - by Ron Ramirez - 05-14-2014, 02:48 PM
RE: 38 23 philco? (bought it) - by Jayce - 05-14-2014, 06:17 PM
RE: 38 23 philco? (bought it) - by KCMike - 05-15-2014, 03:30 PM
RE: 38 23 philco? (bought it) - by Jayce - 05-15-2014, 09:06 PM
RE: 38 23 philco? (bought it) - by OldRestorer - 05-16-2014, 09:16 AM
RE: 38 23 philco? (bought it) - by KCMike - 05-16-2014, 09:34 AM
RE: 38 23 philco? (bought it) - by PhilcoJohn - 05-17-2014, 07:00 PM
RE: 38 23 philco? (bought it) - by jerryhawthorne - 05-18-2014, 02:36 PM
RE: 38 23 philco? (bought it) - by OldRestorer - 05-18-2014, 02:51 PM
RE: 38 23 philco? (bought it) - by TA Forbes - 05-19-2014, 11:36 AM
RE: 38 23 philco? (bought it) - by Arran - 05-19-2014, 11:27 PM
RE: 38 23 philco? (bought it) - by TA Forbes - 05-20-2014, 09:48 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4683 online users. [Complete List]
» 3 Member(s) | 4680 Guest(s)
AvatarAvatarAvatar

>