Philco 89 Last Version Dies around 1200 kHz

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 89 Last Version Dies around 1200 kHz

radiomikee
Junior Member

Posts: 31
Threads: 4
Joined: Aug 2007

09-09-2008, 09:51 AM

Thanks Ron. In fact you are correct; my plate winding was on the preceding interstage coil to the plate of the 39/44 RF. The cathode winding on the oSC was the one I rewound on the OSC coil. I assume it stops oscillating above 1300 due to the way I rewound it, so will rewind it tonight and give a followup report. In the past, whenever I have rewound these, they performed well and were not finicky for me.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 89 Last Version Dies around 1200 kHz - by radiomikee - 09-08-2008, 10:52 AM

Re: Philco 89 Last Version Dies around 1200 kHz - by Ron Ramirez - 09-08-2008, 09:59 PM

Re: Philco 89 Last Version Dies around 1200 kHz - by radiomikee - 09-09-2008, 09:51 AM

Re: Philco 89 Last Version Dies around 1200 kHz - by exray - 09-09-2008, 11:19 PM

Re: Philco 89 Last Version Dies around 1200 kHz - by Texasrocker - 09-10-2008, 04:21 AM

Re: Philco 89 Last Version Dies around 1200 kHz - by radiomikee - 09-10-2008, 09:27 AM

Re: Philco 89 Last Version Dies around 1200 kHz - by radiomikee - 09-10-2008, 10:05 PM

Re: Philco 89 Last Version Dies around 1200 kHz - by Ron Ramirez - 09-10-2008, 11:16 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

Who's Online

There are currently 4942 online users. [Complete List]
» 1 Member(s) | 4941 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me