1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Good radio day!
TA Forbes
Deviate Emeritus
*****
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
#10

05-27-2014, 09:25 PM
NICE catch, Kirk.

The switch on the side is a bass-boost switch on the four-band model 16s, and is a QAVC switch on the five-band model.

Before you do anything on the 16, have the tubes tested. Also verify that it has had the components updated.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Good radio day! - by OldRestorer - 05-25-2014, 01:07 PM
RE: Good radio day! - by OldRestorer - 05-25-2014, 01:08 PM
RE: Good radio day! - by PAradiogeek - 05-25-2014, 01:33 PM
RE: Good radio day! - by gregb - 05-25-2014, 02:07 PM
RE: Good radio day! - by OldRestorer - 05-25-2014, 02:46 PM
RE: Good radio day! - by Eric Adams - 05-25-2014, 03:39 PM
RE: Good radio day! - by OldRestorer - 05-25-2014, 05:07 PM
RE: Good radio day! - by codefox1 - 05-25-2014, 07:05 PM
RE: Good radio day! - by OldRestorer - 05-26-2014, 07:41 AM
RE: Good radio day! - by TA Forbes - 05-27-2014, 09:25 PM
RE: Good radio day! - by codefox1 - 05-28-2014, 01:17 PM
RE: Good radio day! - by PhilcoJohn - 05-28-2014, 07:31 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6553 online users. [Complete List]
» 1 Member(s) | 6552 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios