1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
49-501 question
wonderwrench
Member
***
Posts: 96
Threads: 16
Joined: Oct 2007
#4

08-14-2008, 11:41 AM
Here is more info on the special cap. http://www.antiqueradios.com/forums/view...c6e9960d4b
I would just replace it with a regular cap as Chuck S states.
Should be a .2 MF by looking at the schematic here.
http://www.nostalgiaair.org/Resources/659/M0013659.htm

On the 16B hopefully someone will reply that has seen this problem before as I have not.

BTW all topic reply emails will come from Ron no matter who replies.
Sorry I'm not Ron.
Bill

It's not what you don't know that hurts you it's what you know that's not so.
Find
« Next Oldest | Next Newest »


Messages In This Thread
49-501 question - by tubenutt - 08-13-2008, 10:45 PM
[No subject] - by wonderwrench - 08-13-2008, 11:07 PM
[No subject] - by tubenutt - 08-14-2008, 02:53 AM
[No subject] - by wonderwrench - 08-14-2008, 11:41 AM
[No subject] - by tubenutt - 08-14-2008, 12:10 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently 4123 online users. [Complete List]
» 3 Member(s) | 4120 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration