Stewart Warner alignment issues

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Stewart Warner alignment issues

Eric
Senior Member

Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA

05-31-2014, 09:24 AM

Not a dum question and that's probably where I should go next? The IF(1&2) coils are very responsive so is the broadcast osc (3) and 4&5 only #6 the broadcast osc series padder doesn't appear to do much. I would think an open coil and they wouldn't do anything? I will start and check them one at a time.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Stewart Warner alignment issues - by Eric - 05-29-2014, 01:12 PM

RE: Stewart Warner alignment issues - by morzh - 05-29-2014, 01:25 PM

RE: Stewart Warner alignment issues - by Eric - 05-29-2014, 07:38 PM

RE: Stewart Warner alignment issues - by morzh - 05-29-2014, 07:55 PM

RE: Stewart Warner alignment issues - by BrendaAnnD - 05-29-2014, 08:08 PM

RE: Stewart Warner alignment issues - by Eric - 05-30-2014, 04:32 PM

RE: Stewart Warner alignment issues - by morzh - 05-30-2014, 07:06 PM

RE: Stewart Warner alignment issues - by Eric - 05-31-2014, 09:24 AM

RE: Stewart Warner alignment issues - by Eric - 06-01-2014, 09:15 AM

RE: Stewart Warner alignment issues - by morzh - 06-01-2014, 08:56 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 03:14 PM

RE: Stewart Warner alignment issues - by morzh - 06-02-2014, 03:36 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 04:07 PM

RE: Stewart Warner alignment issues - by morzh - 06-02-2014, 04:54 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 05:04 PM

RE: Stewart Warner alignment issues - by morzh - 06-02-2014, 05:17 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 05:24 PM

RE: Stewart Warner alignment issues - by Eric - 06-03-2014, 05:22 PM

RE: Stewart Warner alignment issues - by morzh - 06-03-2014, 05:25 PM

RE: Stewart Warner alignment issues - by Mondial - 06-03-2014, 06:30 PM

RE: Stewart Warner alignment issues - by Eric - 06-04-2014, 11:48 AM

RE: Stewart Warner alignment issues - by Eric - 06-11-2014, 03:12 PM

RE: Stewart Warner alignment issues - by morzh - 06-11-2014, 03:38 PM

RE: Stewart Warner alignment issues - by Mondial - 06-11-2014, 04:19 PM

RE: Stewart Warner alignment issues - by Eric - 06-11-2014, 05:15 PM

RE: Stewart Warner alignment issues - by morzh - 06-11-2014, 09:15 PM

RE: Stewart Warner alignment issues - by AI2V - 06-12-2014, 05:11 PM

RE: Stewart Warner alignment issues - by Eric - 06-14-2014, 07:34 PM

View a Printable Version

Users browsing this thread: 5 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 5335 online users. [Complete List]
» 2 Member(s) | 5333 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me