Philco 89/19

Thread Rating:

1 Vote(s) - 5 Average
1
2
3
4
5

Linear Mode

Philco 89/19

PAradiogeek
Senior Member

Posts: 395
Threads: 33
Joined: Jul 2013
City: Horsham, PA

05-31-2014, 03:54 PM

Art,

I had a lot of trouble around the band switch, the tone control, and the two large e-caps. There isn't a lot of room and there is a lot of stuff right in that area. In order to be able to remove the tone control to recap that, I needed to unscrew the band switch from the chassis front and pull the shaft back into the chassis. I also had to remove the closest e-cap. It was a lot to take apart to just have access to the tone control. My advice therefore, is to take good notes and/or pictures so that you can get it all back together correctly.

Good luck!
Jon

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 89/19 - by Art Hoch - 05-30-2014, 10:52 AM

RE: Philco 89/19 - by Ron Ramirez - 05-30-2014, 12:58 PM

RE: Philco 89/19 - by exray - 05-31-2014, 05:18 AM

RE: Philco 89/19 - by morzh - 05-31-2014, 10:51 AM

RE: Philco 89/19 - by PAradiogeek - 05-31-2014, 03:54 PM

RE: Philco 89/19 - by Art Hoch - 06-02-2014, 09:47 PM

RE: Philco 89/19 - by gregb - 06-02-2014, 11:05 PM

RE: Philco 89/19 - by PAradiogeek - 06-03-2014, 12:42 AM

RE: Philco 89/19 - by Art Hoch - 06-03-2014, 02:16 PM

RE: Philco 89/19 - by gregb - 06-03-2014, 02:28 PM

RE: Philco 89/19 - by Chuck Schwark - 06-03-2014, 03:10 PM

RE: Philco 89/19 - by Art Hoch - 06-05-2014, 09:32 PM

RE: Philco 89/19 - by Art Hoch - 06-26-2014, 03:55 PM

RE: Philco 89/19 - by Art Hoch - 07-02-2014, 10:49 PM

RE: Philco 89/19 - by PAradiogeek - 07-06-2014, 03:21 PM

RE: Philco 89/19 - by Art Hoch - 07-09-2014, 06:00 PM

RE: Philco 89/19 - by Randy H. - 07-12-2014, 06:14 PM

RE: Philco 89/19 - by Art Hoch - 07-12-2014, 08:57 PM

RE: Philco 89/19 - by Art Hoch - 07-14-2014, 10:44 AM

RE: Philco 89/19 - by Ron Ramirez - 07-14-2014, 10:45 AM

RE: Philco 89/19 - by Art Hoch - 07-14-2014, 08:19 PM

RE: Philco 89/19 - by Art Hoch - 07-23-2014, 12:24 PM

RE: Philco 89/19 - by Ron Ramirez - 07-23-2014, 12:36 PM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me