Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Shouldered Tombstone 116-121
#6

Welcome to this site, Matt. The 116 tombstone is one of the best table sets out there.

Strongly advise:

1. Take a good look at the different areas on this site. MANY questions can be answered here!!

2. Re-stuff the "bakelite block" capacitors under the chassis. The blocks also serve as "tie-down points" for the wiring.


Messages In This Thread
Shouldered Tombstone 116-121 - by mtroy1369 - 06-01-2014, 11:20 PM
RE: Shouldered Tombstone 116-121 - by morzh - 06-02-2014, 09:45 AM
RE: Shouldered Tombstone 116-121 - by codefox1 - 06-02-2014, 01:46 PM
RE: Shouldered Tombstone 116-121 - by AJboy123 - 06-02-2014, 05:45 PM
RE: Shouldered Tombstone 116-121 - by mtroy1369 - 06-03-2014, 05:08 PM
RE: Shouldered Tombstone 116-121 - by TA Forbes - 06-05-2014, 08:38 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4738 online users. [Complete List]
» 1 Member(s) | 4737 Guest(s)
Avatar

>