1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 42 380 Hums well but does not know the words
David B
Member
***
Posts: 53
Threads: 19
Joined: Jan 2008
#3

08-15-2008, 11:44 PM
Harv:

In that I am a newbie, which of the electrolytic capacitors are for the the power supply. I have the schematic, could you give me the values or part number. I noted that perhaps two of the electrolytic's were replaced at some prior point in that there are two big new ones under the chase, but I don't know which ones. So any advice you could offer is greatly appreciated. Further, I plan to order a cap kit for the radio and replace them all, Again thanks .

God bless,

Dave
Find
« Next Oldest | Next Newest »


Messages In This Thread
[No subject] - by mandh - 08-15-2008, 11:12 PM
[No subject] - by David B - 08-15-2008, 11:44 PM
[No subject] - by Texasrocker - 08-16-2008, 01:58 AM
[No subject] - by David B - 08-16-2008, 07:30 AM
[No subject] - by Ron Ramirez - 08-16-2008, 08:38 AM
[No subject] - by David B - 08-16-2008, 06:50 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently 3163 online users. [Complete List]
» 1 Member(s) | 3162 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration