Philco 20 Donated Finished

Thread Rating:

1 Vote(s) - 5 Average
1
2
3
4
5

Linear Mode

Philco 20 Donated Finished

Phlogiston
Radio-Fixer-Upper

Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)

06-13-2014, 03:27 PM

No the tube isn't bad, one of the big pins just corroded off. Just on that tube. It and its brother both test 2000/1650 on my Hickok. I'll just put a new base on it. They were both STs the 380 was also good.

The chassis had some rust on it. I would say about average for that vintage Philco. I have cleaned it up and will touch up the spots. It looks good, only one cap replacement and all of the 24s and 27 are Philco globes.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 20 Donated Finished - by Phlogiston - 06-12-2014, 06:41 PM

RE: Philco 20 Donated - by morzh - 06-12-2014, 07:23 PM

RE: Philco 20 Donated - by klondike98 - 06-12-2014, 09:33 PM

RE: Philco 20 Donated - by Arran - 06-12-2014, 10:16 PM

RE: Philco 20 Donated - by morzh - 06-12-2014, 10:20 PM

RE: Philco 20 Donated - by Phlogiston - 06-12-2014, 10:56 PM

RE: Philco 20 Donated - by GarySP - 06-13-2014, 12:13 PM

RE: Philco 20 Donated - by morzh - 06-13-2014, 03:09 PM

RE: Philco 20 Donated - by Phlogiston - 06-13-2014, 03:27 PM

RE: Philco 20 Donated - by morzh - 06-13-2014, 03:35 PM

RE: Philco 20 Donated - by Phlogiston - 06-13-2014, 06:10 PM

RE: Philco 20 Donated - by Randy H. - 06-16-2014, 04:17 PM

RE: Philco 20 Donated - by morzh - 06-16-2014, 04:23 PM

RE: Philco 20 Donated - by Phlogiston - 07-13-2014, 01:51 AM

RE: Philco 20 Donated - by morzh - 07-13-2014, 10:27 AM

RE: Philco 20 Donated - by Steve Davis - 07-13-2014, 10:39 AM

RE: Philco 20 Donated - by klondike98 - 07-13-2014, 10:45 AM

RE: Philco 20 Donated - by Phlogiston - 07-13-2014, 03:02 PM

RE: Philco 20 Donated - by Phlogiston - 07-13-2014, 08:40 PM

RE: Philco 20 Donated - by morzh - 07-13-2014, 09:31 PM

RE: Philco 20 Donated - by Phlogiston - 07-14-2014, 02:49 AM

RE: Philco 20 Donated - by morzh - 07-14-2014, 08:18 AM

RE: Philco 20 Donated - by Phlogiston - 07-14-2014, 08:45 AM

RE: Philco 20 Donated - by morzh - 07-14-2014, 08:48 AM

RE: Philco 20 Donated - by Phlogiston - 07-14-2014, 09:14 AM

RE: Philco 20 Donated - by klondike98 - 07-14-2014, 09:21 AM

RE: Philco 20 Donated - by Phlogiston - 07-14-2014, 09:36 AM

RE: Philco 20 Donated - by morzh - 07-14-2014, 09:56 AM

RE: Philco 20 Donated Finished - by Phlogiston - 07-17-2014, 01:33 PM

RE: Philco 20 Donated Finished - by morzh - 07-17-2014, 01:49 PM

RE: Philco 20 Donated Finished - by Phlogiston - 07-17-2014, 07:06 PM

RE: Philco 20 Donated Finished - by klondike98 - 07-17-2014, 10:22 PM

RE: Philco 20 Donated Finished - by Phlogiston - 07-18-2014, 12:33 AM

RE: Philco 20 Donated Finished - by Eliot Ness - 07-18-2014, 09:33 AM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM

Who's Online

There are currently 5092 online users. [Complete List]
» 1 Member(s) | 5091 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me