1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco D-10 needle source
w4rtc
Senior Member
****
Posts: 594
Threads: 41
Joined: Aug 2010
City: Shepherdsville, KY
#16

06-14-2014, 07:53 AM
Hi all
I think I have one of these needles. If you are still need it I will hunt for it. Let me know.
Joe
Joe Bratcher near Louisville, KY
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco D-10 needle source - by brownie45 - 05-28-2014, 08:37 AM
RE: Philco D-10 needle source - by TA Forbes - 05-28-2014, 10:50 AM
RE: Philco D-10 needle source - by brownie45 - 05-28-2014, 12:48 PM
RE: Philco D-10 needle source - by sam - 05-28-2014, 01:18 PM
RE: Philco D-10 needle source - by Warren - 05-28-2014, 01:56 PM
RE: Philco D-10 needle source - by TA Forbes - 05-28-2014, 11:17 PM
RE: Philco D-10 needle source - by Ron Ramirez - 05-29-2014, 05:42 AM
RE: Philco D-10 needle source - by brownie45 - 05-29-2014, 06:58 AM
RE: Philco D-10 needle source - by Randy H. - 06-09-2014, 07:11 PM
RE: Philco D-10 needle source - by Ron Ramirez - 06-09-2014, 08:18 PM
RE: Philco D-10 needle source - by brownie45 - 06-09-2014, 09:39 PM
RE: Philco D-10 needle source - by Randy H. - 06-13-2014, 05:46 PM
RE: Philco D-10 needle source - by Ron Ramirez - 06-13-2014, 06:00 PM
RE: Philco D-10 needle source - by Skip - 06-13-2014, 06:11 PM
RE: Philco D-10 needle source - by Warren - 06-13-2014, 10:22 PM
RE: Philco D-10 needle source - by w4rtc - 06-14-2014, 07:53 AM
RE: Philco D-10 needle source - by brownie45 - 06-15-2014, 12:24 PM
RE: Philco D-10 needle source - by w4rtc - 06-15-2014, 05:01 PM
RE: Philco D-10 needle source - by brownie45 - 06-15-2014, 07:02 PM
RE: Philco D-10 needle source - by Warren - 06-15-2014, 08:29 PM
RE: Philco D-10 needle source - by w4rtc - 06-15-2014, 11:22 PM
RE: Philco D-10 needle source - by Warren - 06-16-2014, 01:53 AM
RE: Philco D-10 needle source - by w4rtc - 06-16-2014, 10:35 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration