Stewart Warner alignment issues

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Stewart Warner alignment issues

Eric
Senior Member

Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA

#28

06-14-2014, 07:34 PM

I have noticed that measuring capacitance can be tricky and I lift one end because the readings never seem to come out.

I did have the alignment procedure for that radio but I printed yours they are pretty close . Thanks.

Eric

Find

« Next Oldest | Next Newest »

Messages In This Thread

Stewart Warner alignment issues - by Eric - 05-29-2014, 01:12 PM

RE: Stewart Warner alignment issues - by morzh - 05-29-2014, 01:25 PM

RE: Stewart Warner alignment issues - by Eric - 05-29-2014, 07:38 PM

RE: Stewart Warner alignment issues - by morzh - 05-29-2014, 07:55 PM

RE: Stewart Warner alignment issues - by BrendaAnnD - 05-29-2014, 08:08 PM

RE: Stewart Warner alignment issues - by Eric - 05-30-2014, 04:32 PM

RE: Stewart Warner alignment issues - by morzh - 05-30-2014, 07:06 PM

RE: Stewart Warner alignment issues - by Eric - 05-31-2014, 09:24 AM

RE: Stewart Warner alignment issues - by Eric - 06-01-2014, 09:15 AM

RE: Stewart Warner alignment issues - by morzh - 06-01-2014, 08:56 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 03:14 PM

RE: Stewart Warner alignment issues - by morzh - 06-02-2014, 03:36 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 04:07 PM

RE: Stewart Warner alignment issues - by morzh - 06-02-2014, 04:54 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 05:04 PM

RE: Stewart Warner alignment issues - by morzh - 06-02-2014, 05:17 PM

RE: Stewart Warner alignment issues - by Eric - 06-02-2014, 05:24 PM

RE: Stewart Warner alignment issues - by Eric - 06-03-2014, 05:22 PM

RE: Stewart Warner alignment issues - by morzh - 06-03-2014, 05:25 PM

RE: Stewart Warner alignment issues - by Mondial - 06-03-2014, 06:30 PM

RE: Stewart Warner alignment issues - by Eric - 06-04-2014, 11:48 AM

RE: Stewart Warner alignment issues - by Eric - 06-11-2014, 03:12 PM

RE: Stewart Warner alignment issues - by morzh - 06-11-2014, 03:38 PM

RE: Stewart Warner alignment issues - by Mondial - 06-11-2014, 04:19 PM

RE: Stewart Warner alignment issues - by Eric - 06-11-2014, 05:15 PM

RE: Stewart Warner alignment issues - by morzh - 06-11-2014, 09:15 PM

RE: Stewart Warner alignment issues - by AI2V - 06-12-2014, 05:11 PM

RE: Stewart Warner alignment issues - by Eric - 06-14-2014, 07:34 PM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

Who's Online

There are currently 6347 online users. [Complete List]
» 1 Member(s) | 6346 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me