|
E-cap rebuilding
06-27-2014, 10:04 PM
With the trick I mentioned, I just used hot glue to hold the two halves together, but then again this was an aluminum can and I used a PVC coupling, so soldering was NOT an option like with copper, brass, or steel. Plus it has an electrolytic cap inside which will need to be replaced at some point.
Regards Arran
« Next Oldest | Next Newest »
Messages In This Thread
E-cap rebuilding - by fields 100 - 06-26-2014, 07:15 PM
RE: E-cap rebuilding - by morzh - 06-26-2014, 07:30 PM
RE: E-cap rebuilding - by fields 100 - 06-26-2014, 08:06 PM
RE: E-cap rebuilding - by gregb - 06-26-2014, 10:00 PM
RE: E-cap rebuilding - by fields 100 - 06-26-2014, 10:07 PM
RE: E-cap rebuilding - by gregb - 06-26-2014, 10:13 PM
RE: E-cap rebuilding - by Arran - 06-26-2014, 10:20 PM
RE: E-cap rebuilding - by Phlogiston - 06-27-2014, 12:02 AM
RE: E-cap rebuilding - by fields 100 - 06-27-2014, 01:50 PM
RE: E-cap rebuilding - by Phlogiston - 06-27-2014, 04:08 PM
RE: E-cap rebuilding - by fields 100 - 06-27-2014, 05:36 PM
RE: E-cap rebuilding - by Steve Davis - 06-27-2014, 08:37 PM
RE: E-cap rebuilding - by Arran - 06-27-2014, 10:04 PM
RE: E-cap rebuilding - by fields 100 - 06-27-2014, 10:40 PM
RE: E-cap rebuilding - by fields 100 - 06-28-2014, 06:05 PM
Users browsing this thread: 1 Guest(s) |
