Question about I.F. cans

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Question about I.F. cans

Eric T
Senior Member

Posts: 298
Threads: 22
Joined: May 2012
City: Chattanooga State, Province, Country: TN

06-28-2014, 02:07 PM

I had originally gone in there to replace the rubber insulation on the input/output wires and the internal 47K resistor (34C) because it's value had drifted beyond tolerance.

I was just asking about those caps because I saw nothing in there but the coils and a resistor. I try to measure every component to evaluate whether or not they need to be replaced. Now I have learned more about them. Thanks, gents.

It's not how bad you mess up, it's how well you can recover.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Question about I.F. cans - by Eric T - 06-21-2014, 01:47 PM

RE: Question about I.F. cans - by Ron Ramirez - 06-21-2014, 03:41 PM

RE: Question about I.F. cans - by Eric T - 06-22-2014, 02:37 PM

RE: Question about I.F. cans - by codefox1 - 06-26-2014, 10:39 AM

RE: Question about I.F. cans - by exray - 06-26-2014, 08:41 PM

RE: Question about I.F. cans - by Eric T - 06-28-2014, 02:07 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me