1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
42-1011 chassis issues
davidff
Member
***
Posts: 83
Threads: 30
Joined: Aug 2011
City: SOUTHINGTON, CT
#3

07-07-2014, 09:33 AM
The only sound is a very low hum, and when I push the buttons, just a scratchy sound. No volume changes with turning the dial either. I will check the countinuity on the coils. Thanks for the reply.
Find
« Next Oldest | Next Newest »


Messages In This Thread
42-1011 chassis issues - by davidff - 07-07-2014, 07:55 AM
RE: 42-1011 chassis issues - by morzh - 07-07-2014, 08:59 AM
RE: 42-1011 chassis issues - by davidff - 07-07-2014, 09:33 AM
RE: 42-1011 chassis issues - by morzh - 07-07-2014, 09:37 AM
RE: 42-1011 chassis issues - by davidff - 07-07-2014, 09:48 AM
RE: 42-1011 chassis issues - by morzh - 07-07-2014, 10:00 AM
RE: 42-1011 chassis issues - by morzh - 07-07-2014, 10:06 AM
RE: 42-1011 chassis issues - by davidff - 07-09-2014, 07:43 AM
RE: 42-1011 chassis issues - by Ron Ramirez - 07-09-2014, 04:29 PM
RE: 42-1011 chassis issues - by davidff - 07-11-2014, 08:36 AM
RE: 42-1011 chassis issues - by Arran - 07-11-2014, 01:11 PM
RE: 42-1011 chassis issues - by Warren - 07-11-2014, 01:19 PM
RE: 42-1011 chassis issues - by morzh - 07-11-2014, 03:02 PM
RE: 42-1011 chassis issues - by davidff - 07-14-2014, 02:08 PM
RE: 42-1011 chassis issues - by morzh - 07-14-2014, 02:56 PM
RE: 42-1011 chassis issues - by davidff - 07-15-2014, 08:00 AM
RE: 42-1011 chassis issues - by morzh - 07-15-2014, 08:59 AM
RE: 42-1011 chassis issues - by TA Forbes - 07-15-2014, 09:03 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W  1.5k  ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM

[-]
Who's Online
There are currently 3837 online users. [Complete List]
» 4 Member(s) | 3833 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration