Philco 48-1256 (was: Bulb Identification)

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 48-1256 (was: Bulb Identification)

KidCarter
Junior Member

Posts: 9
Threads: 1
Joined: Jul 2014
City: Worcester

07-08-2014, 10:23 PM

Hello all,
I was hoping to replace a bulb on my 48 Philco but I couldn't find out what kind it is or where I would get it. It is not a tube, its actually the little light bulb that sits behind the glass. The previous owner must have thrown the other one away and I have no clue.
-Chris

NOTE: Thread title edited by site admin.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 48-1256 (was: Bulb Identification) - by KidCarter - 07-08-2014, 10:23 PM

RE: Bulb Identification - by Eric Adams - 07-09-2014, 01:14 AM

RE: Bulb Identification - by klondike98 - 07-09-2014, 12:22 PM

RE: Bulb Identification - by Carl Travis - 07-09-2014, 02:35 PM

RE: Bulb Identification - by klondike98 - 07-09-2014, 03:41 PM

RE: Bulb Identification - by KidCarter - 07-09-2014, 04:02 PM

RE: Bulb Identification - by Carl Travis - 07-09-2014, 04:31 PM

RE: Bulb Identification - by KidCarter - 07-09-2014, 06:08 PM

RE: Bulb Identification - by KidCarter - 07-09-2014, 10:19 PM

RE: Bulb Identification - by Warren - 07-10-2014, 12:08 AM

RE: Bulb Identification - by KidCarter - 07-12-2014, 11:31 AM

RE: Bulb Identification - by klondike98 - 07-12-2014, 05:19 PM

RE: Bulb Identification - by codefox1 - 07-13-2014, 01:14 PM

RE: Bulb Identification - by KidCarter - 07-14-2014, 07:35 PM

RE: Bulb Identification - by Squire - 07-19-2014, 12:08 PM

RE: Bulb Identification - by KidCarter - 07-19-2014, 11:24 PM

RE: Bulb Identification - by Squire - 07-20-2014, 12:54 AM

RE: Bulb Identification - by Warren - 07-20-2014, 02:32 AM

RE: Bulb Identification - by klondike98 - 07-20-2014, 10:09 AM

RE: Bulb Identification - by KidCarter - 07-20-2014, 11:04 AM

RE: Bulb Identification - by Squire - 07-20-2014, 01:14 PM

RE: Bulb Identification - by KidCarter - 07-21-2014, 09:55 PM

RE: Bulb Identification - by Warren - 07-21-2014, 11:26 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5024 online users. [Complete List]
» 1 Member(s) | 5023 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me