Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Brunswick Panatrope with Radio S31
#15

As far as I can tell everything is original. There are a few flaws in the finish that do not show up on camera, small pieces of veneer chipped out on an egde etc., but nothing major. Should clean up very nicely. I thought for the price I got it for, a 2 hour drive was worth it. The only things I have noticed during initial cleaning are the power cord is frayed in a couple of places (no biggie) and the dial scale is popped loose from the tiny rivets that hold it in place at both ends, the center rivets are still holding. I found a source for a reproduction of the original owner's manual, and I will order it soon. The felt on the turntable is in really good shape, but extremely dirty. A good cleaning with something (?) will probably make a huge difference in it's appearance. Hopefully I can collect all the tubes I need soon and start on getting it working.....along with the other half dozen radios that need fixed. Icon_smile


Messages In This Thread
RE: Brunswick Panatrope with Radio S31 - by morzh - 07-11-2014, 05:14 PM
RE: Brunswick Panatrope with Radio S31 - by Arran - 07-13-2014, 08:46 AM
RE: Brunswick Panatrope with Radio S31 - by sam - 07-14-2014, 10:37 PM
RE: Brunswick Panatrope with Radio S31 - by Groundhog74 - 07-15-2014, 07:30 AM
RE: Brunswick Panatrope with Radio S31 - by Arran - 07-16-2014, 10:45 AM
RE: Brunswick Panatrope with Radio S31 - by sam - 07-16-2014, 12:21 PM
RE: Brunswick Panatrope with Radio S31 - by Arran - 07-17-2014, 12:51 PM
RE: Brunswick Panatrope with Radio S31 - by morzh - 08-08-2014, 09:39 AM
RE: Brunswick Panatrope with Radio S31 - by morzh - 08-08-2014, 09:55 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 5054 online users. [Complete List]
» 2 Member(s) | 5052 Guest(s)
AvatarAvatar

>