Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA 68R3 Help
#8

It will have to wait till Monday as I'm headed to Lexington Ky till Sunday. I do have some questions,
If it is c-33 on the print 2.2-13mmf I have a 5 &10mmf I would like to solder one of them in to see if I can get the FM to work do I need to remove the trimmer or can I parallel it?


Messages In This Thread
RCA 68R3 Help - by Eric - 07-16-2014, 03:27 PM
RE: RCA 68R3 Help - by exray - 07-16-2014, 07:28 PM
RE: RCA 68R3 Help - by Eric - 07-16-2014, 09:28 PM
RE: RCA 68R3 Help - by Eric - 07-17-2014, 11:03 AM
RE: RCA 68R3 Help - by exray - 07-17-2014, 03:50 PM
RE: RCA 68R3 Help - by morzh - 07-17-2014, 04:18 PM
RE: RCA 68R3 Help - by exray - 07-17-2014, 06:08 PM
RE: RCA 68R3 Help - by Eric - 07-17-2014, 07:46 PM
RE: RCA 68R3 Help - by exray - 07-17-2014, 09:33 PM
RE: RCA 68R3 Help - by Eric - 07-21-2014, 05:24 PM
RE: RCA 68R3 Help - by exray - 07-21-2014, 08:16 PM
RE: RCA 68R3 Help - by Eric - 07-22-2014, 08:43 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4828 online users. [Complete List]
» 3 Member(s) | 4825 Guest(s)
AvatarAvatarAvatar

>