Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

More 91X pics
#1

I finally had a few minutes free to pull the chassis and back of my acquisition and check things over. Very clean chassis, no rust whatsoever. Underneath only repair is the replacement of the AC line caps. There are signs of melted wax from the power transformer that I am a little concerned about, but everything looks okay otherwise. The speakers are darn near mint!!!! Also found about 100ft of heavy gauge antenna wire coiled up behind the back panel! Still has the two original 42 globe amp tubes which is pretty neat. One tube has a "New" 12-6-53 sticker on it, so this set was going for awhile. So, for now I did a quick clean up on the chassis and cabinet and it now resides in my house. Now! Back to my chores!
P.S. Why is it that there is ALWAYS at least one missing chassis mounting screw?!!!!!!!
[Image: http://i1160.photobucket.com/albums/q500...01fd81.jpg]
[Image: http://i1160.photobucket.com/albums/q500...05f5dc.jpg]
[Image: http://i1160.photobucket.com/albums/q500...2968f5.jpg]
[Image: http://i1160.photobucket.com/albums/q500...cb992e.jpg]
[Image: http://i1160.photobucket.com/albums/q500...96ef4b.jpg]
[Image: http://i1160.photobucket.com/albums/q500...7491eb.jpg]
[Image: http://i1160.photobucket.com/albums/q500...ed9809.jpg]


Messages In This Thread
More 91X pics - by 37silverstreak - 07-19-2014, 09:03 PM
RE: More 91X pics - by Paul Philco322 - 07-19-2014, 09:32 PM
RE: More 91X pics - by sam - 07-19-2014, 09:36 PM
RE: More 91X pics - by Arran - 07-20-2014, 05:21 AM
RE: More 91X pics - by Art Hoch - 07-20-2014, 09:16 AM
RE: More 91X pics - by Radioroslyn - 07-20-2014, 04:58 PM
RE: More 91X pics - by Jayce - 07-20-2014, 09:33 PM
RE: More 91X pics - by TA Forbes - 07-21-2014, 05:07 PM
RE: More 91X pics - by klondike98 - 07-21-2014, 05:24 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>