Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Value of my Philco Antique Radio
#2

Hello,

It looks like a model 41-285, for model year 1941. It would've been made between 1940 and 1941. As to the value, that's hard to say. From what I can tell by the photograph it looks to be in excellent condition, but electroniclly a photograph can't convey it's condition. Has it been re-capped? Electroniclly restored? A listing on ebay might find you a buyer. Not many people want to ship a large console but maybe you could find a local buyer through an antique radio club in your area. Maybe some of the others on the forum can give you better advice. Good luck and welcome to the phorum.

Mike


Messages In This Thread
Value of my Philco Antique Radio - by Guest - 09-15-2008, 06:40 AM
Re: Value of my Philco Antique Radio - by Michael Dennis - 09-15-2008, 07:50 PM
Re: Value of my Philco Antique Radio - by AI2V - 09-16-2008, 11:21 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently no members online.

>