37 116 veneer cracking

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

37 116 veneer cracking

SteveJB
Member

Posts: 236
Threads: 43
Joined: Oct 2010
City: Atlantic Highlands, NJ

07-26-2014, 04:08 PM

I am trying to repair the cracked curved veneer on the top of my Philco 37 116. This is a typical problem on these cabinets.

I would like the veneer to open up enough so I can get some glue inside. Right now it is too tight to the cabinet to get glue under it. If I could lift it a bit that could work well.

Does anyone have a method to do this?

I welcome any ideas you may have.

Thanks,
Steve

Find

« Next Oldest | Next Newest »

Messages In This Thread

37 116 veneer cracking - by SteveJB - 07-26-2014, 04:08 PM

RE: 37 116 veneer cracking - by tab10672 - 07-26-2014, 07:28 PM

RE: 37 116 veneer cracking - by SteveJB - 07-27-2014, 06:53 PM

RE: 37 116 veneer cracking - by jerryhawthorne - 07-28-2014, 04:42 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM
Philco 38-7 Speaker
7K should be fine. While not a perfect match (This transformer is meant for 6V6 tubes), Antique Electronic Supply (AES)...MrFixr55 — 08:03 AM

Who's Online

There are currently 2859 online users. [Complete List]
» 3 Member(s) | 2856 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me