Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Heathkit SG
#1

I recently bought a frequency counter to check my heathkit sig gen and although I restored it several years ago and have had no problems with it when I check it with the counter, as long as the output dial on the gen is set on low the freq is dead on but as I increase the output on the gen the frequency climbs on the counter. Shouldn't the frequency that the gen is set to stay the same no matter how much the output is increased?

Thanks, Todd


Messages In This Thread
Heathkit SG - by tab10672 - 07-27-2014, 09:30 PM
RE: Heathkit SG - by Ron Ramirez - 07-27-2014, 09:34 PM
RE: Heathkit SG - by codefox1 - 07-29-2014, 01:17 AM
RE: Heathkit SG - by morzh - 07-29-2014, 10:29 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently 4048 online users. [Complete List]
» 1 Member(s) | 4047 Guest(s)
Avatar

>