ZENITH chassis 1004

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

ZENITH chassis 1004

etech
Member

Posts: 237
Threads: 24
Joined: Dec 2007
City: Gladwin, MI

10-26-2008, 10:42 PM

Quote:I then replaced the rest of the caps. and one resistor.Turned it back on and can only recieve 1 statio at around 1400 and at low volume.Rechecked all work,then checked tubes,variable cap. for bents plates or ground issues.Any suggestions would be appreciated.ron

Most likely a wiring error. Double check all connections made during cap and resistor replacement. Also, there is a slight possibility that one of the new caps could be a wrong value or bad. It is usually best to try the radio after replacing each capacitor or every two capacitors, so that if something goes wrong, you don't have too far to trackback. Icon_smile

Find

« Next Oldest | Next Newest »

Messages In This Thread

ZENITH chassis 1004 - by theboyzz - 10-26-2008, 12:44 PM

Re: ZENITH chassis 1004 - by etech - 10-26-2008, 10:42 PM

Re: ZENITH chassis 1004 - by exray - 10-28-2008, 06:10 AM

Re: ZENITH chassis 1004 - by Texasrocker - 10-30-2008, 01:12 AM

Re: ZENITH chassis 1004 - by BDM - 10-30-2008, 12:47 PM

Re: ZENITH chassis 1004 - by exray - 10-30-2008, 06:12 PM

Re: ZENITH chassis 1004 - by BDM - 10-30-2008, 07:19 PM

Re: ZENITH chassis 1004 - by exray - 10-30-2008, 09:18 PM

Re: ZENITH chassis 1004 - by BDM - 10-30-2008, 09:22 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

Who's Online

There are currently 3433 online users. [Complete List]
» 1 Member(s) | 3432 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me