|
Cutting electrolytic cans open
09-21-2008, 08:09 PM
Quote:That's what I'm going to do. Cut below the clamp line, using a pipe cutter. Gives a fast clean cut. Over a sink of course I considered using a pipe cutter also, but decided against it because I was concerned that the pipe cutter would bend the soft aluminum. I have noticed this effect when using the pipe cutter to cut copper pipe, although in that situation it would not be a problem. Ed
« Next Oldest | Next Newest »
Messages In This Thread
Cutting electrolytic cans open - by BDM - 09-21-2008, 07:14 PM
Re: Cutting electrolytic cans open - by etech - 09-21-2008, 07:35 PM
Re: Cutting electrolytic cans open - by BDM - 09-21-2008, 07:38 PM
Re: Cutting electrolytic cans open - by Ron Ramirez - 09-21-2008, 07:55 PM
Re: Cutting electrolytic cans open - by etech - 09-21-2008, 08:09 PM
Re: Cutting electrolytic cans open - by BDM - 09-21-2008, 08:29 PM
Re: Cutting electrolytic cans open - by mandh - 09-22-2008, 06:32 AM
Re: Cutting electrolytic cans open - by Chuck Schwark - 09-22-2008, 08:27 AM
Users browsing this thread: 1 Guest(s) |
