Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My new/old Zenith 7S240 chairside!
#12

Exactly Mike!
I was pulling the chassis and it was very hard to get that one switch out. it actually scratched the inside of the cabinet while I slowly removed it.

It is a side mount and comes out sideways too.

As for the knobs, I got really lucky a while ago and got about 8 in a big lot of knobs. Hopefully the right ones. See pics, are one of these the correct ones? Is the one on the set original? I have seen it with the large flat one.

Oh and as for the eye tubes, not 6T5's Icon_redface

5 6U5's 2 6E5's and a 2E5. Not sure if the one in it is a 6T5 and I aint taking the chassis out again.


Attached Files Image(s)
                   

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6


Messages In This Thread
RE: My new/old Zenith 7S240 chairside! - by sam - 08-03-2014, 12:15 PM
RE: My new/old Zenith 7S240 chairside! - by morzh - 08-03-2014, 04:27 PM
RE: My new/old Zenith 7S240 chairside! - by morzh - 08-03-2014, 05:33 PM
RE: My new/old Zenith 7S240 chairside! - by JimZ - 08-04-2014, 05:29 PM
RE: My new/old Zenith 7S240 chairside! - by morzh - 08-04-2014, 09:18 PM
RE: My new/old Zenith 7S240 chairside! - by Arran - 08-04-2014, 10:24 PM
RE: My new/old Zenith 7S240 chairside! - by OldRestorer - 08-05-2014, 05:46 AM
RE: My new/old Zenith 7S240 chairside! - by morzh - 08-05-2014, 10:45 AM
RE: My new/old Zenith 7S240 chairside! - by Arran - 08-06-2014, 12:53 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>