1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 48-482 (sort of)
Phlogiston
Radio-Fixer-Upper
*****
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
#20

08-05-2014, 10:01 AM
The grain and tone of the front is a faux finish, but not like earlier finishes since it appears to be painted on rather than a transfer. Some of the grain of the wood does show through. It can be reproduced.

Refinished:

   
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 48-482 (sort of) - by VntgRads - 09-14-2013, 10:45 PM
RE: Philco 48-482 (sort of) - by Radioroslyn - 09-15-2013, 07:33 AM
RE: Philco 48-482 (sort of) - by codefox1 - 09-15-2013, 08:44 AM
RE: Philco 48-482 (sort of) - by Jamie - 09-15-2013, 11:15 AM
RE: Philco 48-482 (sort of) - by Phlogiston - 09-15-2013, 02:46 PM
RE: Philco 48-482 (sort of) - by VntgRads - 09-15-2013, 03:02 PM
RE: Philco 48-482 (sort of) - by Phlogiston - 09-15-2013, 03:49 PM
RE: Philco 48-482 (sort of) - by codefox1 - 09-15-2013, 06:43 PM
RE: Philco 48-482 (sort of) - by marty - 09-15-2013, 06:55 PM
RE: Philco 48-482 (sort of) - by Phlogiston - 09-15-2013, 07:43 PM
RE: Philco 48-482 (sort of) - by jerryhawthorne - 09-15-2013, 07:52 PM
RE: Philco 48-482 (sort of) - by VntgRads - 09-15-2013, 08:02 PM
RE: Philco 48-482 (sort of) - by Phlogiston - 09-16-2013, 12:04 AM
RE: Philco 48-482 (sort of) - by Arran - 09-16-2013, 12:43 AM
RE: Philco 48-482 (sort of) - by Eric Adams - 09-16-2013, 01:14 AM
RE: Philco 48-482 (sort of) - by VntgRads - 09-16-2013, 01:17 AM
RE: Philco 48-482 (sort of) - by mikethedruid - 08-05-2014, 01:07 AM
RE: Philco 48-482 (sort of) - by OldRestorer - 08-05-2014, 06:33 AM
RE: Philco 48-482 (sort of) - by Phlogiston - 08-05-2014, 10:01 AM
RE: Philco 48-482 (sort of) - by klondike98 - 08-05-2014, 10:08 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios