Grundig 5008

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Grundig 5008

murf
Senior Member

Posts: 668
Threads: 144
Joined: Jun 2011
City: Elko,MN.

#26

08-08-2014, 09:00 PM

Havent found one yet.
Here is an interesting problem,
The lights on each side of the dial illuminate, but yet they do not illuminate the dial.
If I shine a bright light in the hole, they kind of light up the dial, but not like they should.
I know you are going to say, the light hles are plugged up, or the lights are not bright enough.
Any other obvious suggestions?
murf

(This post was last modified: 08-08-2014, 10:37 PM by murf.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Grundig 5008 - by Art Hoch - 07-16-2014, 11:51 AM

RE: Grundig 5008 - by morzh - 07-16-2014, 04:26 PM

RE: Grundig 5008 - by Art Hoch - 07-16-2014, 06:08 PM

RE: Grundig 5008 - by morzh - 07-16-2014, 08:46 PM

RE: Grundig 5008 - by Art Hoch - 07-20-2014, 09:14 AM

RE: Grundig 5008 - by Arran - 07-20-2014, 02:04 PM

RE: Grundig 5008 - by Art Hoch - 07-20-2014, 03:54 PM

RE: Grundig 5008 - by codefox1 - 07-20-2014, 10:13 PM

RE: Grundig 5008 - by Art Hoch - 07-20-2014, 11:27 PM

RE: Grundig 5008 - by gregb - 07-20-2014, 11:41 PM

RE: Grundig 5008 - by morzh - 07-20-2014, 11:48 PM

RE: Grundig 5008 - by Arran - 07-21-2014, 03:26 AM

RE: Grundig 5008 - by Art Hoch - 07-21-2014, 11:19 PM

RE: Grundig 5008 - by Art Hoch - 07-22-2014, 12:44 PM

RE: Grundig 5008 - by Art Hoch - 07-26-2014, 05:43 PM

RE: Grundig 5008 - by Art Hoch - 07-28-2014, 08:00 PM

RE: Grundig 5008 - by morzh - 07-28-2014, 11:05 PM

RE: Grundig 5008 - by Art Hoch - 07-29-2014, 11:18 AM

RE: Grundig 5008 - by morzh - 07-29-2014, 12:10 PM

RE: Grundig 5008 - by Art Hoch - 07-30-2014, 05:34 PM

RE: Grundig 5008 - by Arran - 07-30-2014, 08:08 PM

RE: Grundig 5008 - by Art Hoch - 07-31-2014, 10:46 AM

RE: Grundig 5008 - by Art Hoch - 08-04-2014, 09:16 PM

RE: Grundig 5008 - by murf - 08-06-2014, 08:02 PM

RE: Grundig 5008 - by Art Hoch - 08-08-2014, 08:35 PM

RE: Grundig 5008 - by murf - 08-08-2014, 09:00 PM

RE: Grundig 5008 - by Art Hoch - 08-09-2014, 10:20 PM

RE: Grundig 5008 - by Art Hoch - 08-09-2014, 10:24 PM

RE: Grundig 5008 - by Ron Ramirez - 08-10-2014, 07:25 AM

RE: Grundig 5008 - by Art Hoch - 08-13-2014, 06:06 PM

RE: Grundig 5008 - by Art Hoch - 08-22-2014, 02:24 PM

RE: Grundig 5008 - by Art Hoch - 08-29-2014, 12:41 PM

View a Printable Version

Users browsing this thread: 8 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 7221 online users. [Complete List]
» 3 Member(s) | 7218 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me