Philco 42-1010 Dial Stringing

Thread Rating:

Ron Ramirez
Silent Key

Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana

12-13-2005, 01:30 PM

I have a 42-1011, and have a spare 42-1010 (same chassis) out in the garage. Will check it and report later...

--
Ron Ramirez
Ferdinand IN

Find

« Next Oldest | Next Newest »

Messages In This Thread

[No subject] - by Terry Judkins - 12-13-2005, 12:24 AM

[No subject] - by Chuck Schwark - 12-13-2005, 09:55 AM

[No subject] - by Jon Scaptura - 12-13-2005, 10:23 AM

[No subject] - by Chuck Schwark - 12-13-2005, 11:58 AM

[No subject] - by Ron Ramirez - 12-13-2005, 01:30 PM

[No subject] - by Jon Scaptura - 12-13-2005, 04:45 PM

[No subject] - by Ron Ramirez - 12-13-2005, 05:58 PM

[No subject] - by Ron Ramirez - 12-13-2005, 06:53 PM

[No subject] - by Chuck Schwark - 12-13-2005, 08:16 PM

Thanks - by Jon Scaptura - 12-13-2005, 11:36 PM

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 6224 online users. [Complete List]
» 4 Member(s) | 6220 Guest(s)