1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
A little Z restoration Chronicle DONE
Fred Taylor
Phorum Expert
*****
Posts: 765
Threads: 147
Joined: Aug 2012
City: Dallas, TX
#5

08-23-2014, 09:21 PM
If the dial cover is not cracked or warped you may try using automotive rubbing compound use a very small buffing wheel/pad or by hand works very well. the cover will retain its patina look and you will be able to see the dial well .save your money
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: A little Z restoration Chronicle - by Fred Taylor - 08-23-2014, 09:21 PM
RE: A little Z restoration Chronicle - by morzh - 08-27-2014, 11:51 AM
RE: A little Z restoration Chronicle - by morzh - 08-27-2014, 03:29 PM
RE: A little Z restoration Chronicle - by morzh - 09-03-2014, 08:14 PM
RE: A little Z restoration Chronicle - by morzh - 09-03-2014, 09:30 PM
RE: A little Z restoration Chronicle - by sam - 09-04-2014, 11:55 AM
RE: A little Z restoration Chronicle - by morzh - 09-04-2014, 01:47 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 01:47 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 02:49 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 04:32 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 05:10 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 05:44 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 07:23 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 08:45 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

[-]
Who's Online
There are currently 5980 online users. [Complete List]
» 1 Member(s) | 5979 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)