Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 42-395
#3

Thanks Ron....Really just wanted to know or maybe converse with someone who has one.
Have seen a lot of discussions on other Philcos...just have not found any on the 42-395
Of course, as you know, I am still searching for the bezel.

Love this site and going through some of the different "phorums."

Thanks again Icon_biggrin


Messages In This Thread
Philco 42-395 - by Guest - 10-12-2008, 07:36 AM
RE: Philco 42-395 - by lasttoknow - 05-25-2012, 12:23 PM
Re: Philco 42-395 - by Ron Ramirez - 10-12-2008, 11:14 AM
Re: Philco 42-395 - by Guest - 10-12-2008, 12:40 PM
Re: Philco 42-395 - by Ron Ramirez - 10-13-2008, 07:09 PM
Re: Philco 42-395 - by Guest - 11-15-2008, 10:38 AM
Re: Philco 42-395 - by Ron Ramirez - 11-15-2008, 02:49 PM
Re: Philco 42-395 - by Guest - 11-15-2008, 03:32 PM
Re: Philco 42-395 - by Guest - 12-28-2008, 04:50 PM
Re: Philco 42-395 - by Doug Houston - 12-28-2008, 05:14 PM
Re: Philco 42-395 - by Guest - 12-28-2008, 06:16 PM
Re: Philco 42-395 - by 49Stude63 - 12-30-2008, 01:20 PM
Re: Philco 42-395 - by Guest - 12-30-2008, 02:06 PM
Re: Philco 42-395 - by 49Stude63 - 12-30-2008, 02:10 PM
Re: Philco 42-395 - by Guest - 12-30-2008, 02:25 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM

[-]
Who's Online
There are currently no members online.

>