Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A little Z restoration Chronicle DONE
#32

Case in point: your French is even worth. From Kirk
See Kirk, you may have wanted to say it was worse!
Mike, don't blame it on the key pad, you can see what is typed on the screen.
I do believe your friends but doubt Kirk can figure out how to put the B+ to ground yet, but he is learning. I guess Mike he has to learn to solder first?
Best to both and enjoy your posts.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
RE: A little Z restoration Chronicle - by morzh - 08-27-2014, 11:51 AM
RE: A little Z restoration Chronicle - by morzh - 08-27-2014, 03:29 PM
RE: A little Z restoration Chronicle - by morzh - 09-03-2014, 08:14 PM
RE: A little Z restoration Chronicle - by morzh - 09-03-2014, 09:30 PM
RE: A little Z restoration Chronicle - by sam - 09-04-2014, 11:55 AM
RE: A little Z restoration Chronicle - by morzh - 09-04-2014, 01:47 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 01:47 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 02:49 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 04:32 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 05:10 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 05:44 PM
RE: A little Z restoration Chronicle - by jerryhawthorne - 09-05-2014, 06:00 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 07:23 PM
RE: A little Z restoration Chronicle - by morzh - 09-05-2014, 08:45 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4945 online users. [Complete List]
» 3 Member(s) | 4942 Guest(s)
AvatarAvatarAvatar

>