1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco Transitone 46-250 Code 125.
morzh
Odobenus rosmarus
*****
Posts: 15,819
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
#22

09-06-2014, 08:05 PM
Aligned it.

Works just fine!

Will try to find a repro back cover. Those wires from the loop are unsightly.

Hope this is it!


PS. Found on eBay and outside (same company, Retro-tronics).
Realized I only have one clip that holds it in the back.
Anyone knows where to get those?
(This post was last modified: 09-06-2014, 08:19 PM by morzh.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco Transitone 46-250 Code 125. - by morzh - 08-31-2014, 08:31 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-01-2014, 11:32 AM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-01-2014, 12:15 PM
RE: Philco Transitone 46-250 Code 125. - by sam - 09-01-2014, 02:30 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-01-2014, 03:42 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-01-2014, 06:33 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-03-2014, 10:47 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-04-2014, 08:48 AM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-04-2014, 08:12 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-04-2014, 10:39 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-05-2014, 08:11 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-05-2014, 08:29 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-06-2014, 12:41 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-06-2014, 05:43 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-06-2014, 08:05 PM
RE: Philco Transitone 46-250 Code 125. - by morzh - 09-06-2014, 08:54 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently 3724 online users. [Complete List]
» 1 Member(s) | 3723 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration