Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

unknown radio
#1

Dear Sirs .

I am french and new member in this forum

I have a question .

I have possibility to adquire one radio set from an advertisement site , but I cannot find the model in your galleries .

It seems to me the radio could be from around 1935 , bur no fotos match the model in the different galleries year by year .

Here affter you will find three fotos of this radio set : one showing front , one from back showing chassis , and one of the label , which also do not match the different label models as described in the explanations of evolution of the Philco labelling over the years .

Hoping you will be able to help Thanks in advance

best regards

claude


Attached Files Image(s)
           


Messages In This Thread
unknown radio - by claude.france - 09-08-2014, 10:02 AM
RE: unknown radio - by klondike98 - 09-08-2014, 04:55 PM
RE: unknown radio - by morzh - 09-08-2014, 07:16 PM
RE: unknown radio - by Ron Ramirez - 09-08-2014, 08:03 PM
RE: unknown radio - by Arran - 09-09-2014, 02:23 AM
RE: unknown radio - by claude.france - 09-09-2014, 04:45 AM
RE: unknown radio - by klondike98 - 09-09-2014, 12:35 PM
RE: unknown radio - by claude.france - 09-09-2014, 03:07 PM
RE: unknown radio - by Ron Ramirez - 09-09-2014, 03:54 PM
RE: unknown radio - by klondike98 - 09-09-2014, 05:00 PM
RE: unknown radio - by Arran - 09-09-2014, 09:57 PM
RE: unknown radio - by claude.france - 09-10-2014, 03:49 AM
RE: unknown radio - by claude.france - 09-10-2014, 07:57 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4352 online users. [Complete List]
» 1 Member(s) | 4351 Guest(s)
Avatar

>