Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Murdock Neutradyne?
#8

If the trans is bad, you can bypass with caps and resistors. Look for 511 trans bypass in tech section is where I think I read it. Those trans are high impedance so they can be hard to check with a digital meter. the jack before the second trans is for headphones the one after is for the horn. Batteries should be 5va, (filament) 22, 45, 90vb (first trans, second trans, horn)on the ones I have anyway. Stewart Warner model 300 is a good generic trf schematic.


Messages In This Thread
Murdock Neutradyne? - by OZ4 - 09-08-2014, 03:12 PM
RE: Murdock Neutradyne? - by OZ4 - 09-08-2014, 03:14 PM
RE: Murdock Neutradyne? - by Radioroslyn - 09-08-2014, 06:00 PM
RE: Murdock Neutradyne? - by OZ4 - 09-08-2014, 06:45 PM
RE: Murdock Neutradyne? - by Eliot Ness - 09-08-2014, 07:43 PM
RE: Murdock Neutradyne? - by Arran - 09-09-2014, 03:01 AM
RE: Murdock Neutradyne? - by OZ4 - 09-10-2014, 12:42 AM
RE: Murdock Neutradyne? - by tab10672 - 09-10-2014, 02:06 PM
RE: Murdock Neutradyne? - by Radioroslyn - 09-14-2014, 06:41 PM
RE: Murdock Neutradyne? - by OZ4 - 09-14-2014, 07:46 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

[-]
Who's Online
There are currently 4769 online users. [Complete List]
» 1 Member(s) | 4768 Guest(s)
Avatar

>