1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Alignment.
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#6

09-30-2014, 06:03 PM
Well whatever is going on you don't have enough turns on your coil to bring 800kc down to 600kc. So you could add some more turns until you the low end of the dial where it should be. I'd go with 15-20 turns till the low end is correct. Then you can see where the top is.
Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Alignment. - by fields 100 - 09-29-2014, 05:50 PM
RE: Alignment. - by Radioroslyn - 09-29-2014, 10:33 PM
RE: Alignment. - by fields 100 - 09-29-2014, 11:36 PM
RE: Alignment. - by Radioroslyn - 09-30-2014, 07:36 AM
RE: Alignment. - by fields 100 - 09-30-2014, 08:21 AM
RE: Alignment. - by Radioroslyn - 09-30-2014, 06:03 PM
RE: Alignment. - by fields 100 - 09-30-2014, 06:53 PM
RE: Alignment. - by Radioroslyn - 09-30-2014, 09:20 PM
RE: Alignment. - by fields 100 - 09-30-2014, 10:51 PM
RE: Alignment. - by Radioroslyn - 10-01-2014, 08:07 PM
RE: Alignment. - by morzh - 10-01-2014, 09:00 PM
RE: Alignment. - by fields 100 - 10-01-2014, 11:04 PM
RE: Alignment. - by mikethedruid - 10-03-2014, 01:37 AM
RE: Alignment. - by fields 100 - 10-03-2014, 08:31 AM
RE: Alignment. - by AI2V - 10-04-2014, 12:07 PM
RE: Alignment. - by fields 100 - 10-05-2014, 07:13 AM
RE: Alignment. - by Radioroslyn - 10-05-2014, 10:11 AM
RE: Alignment. - by Mondial - 10-05-2014, 10:37 AM
RE: Alignment. - by AI2V - 10-05-2014, 12:05 PM
RE: Alignment. - by fields 100 - 10-06-2014, 07:30 AM
RE: Alignment. - by Mondial - 10-06-2014, 10:20 AM
RE: Alignment. - by fields 100 - 10-06-2014, 12:12 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

[-]
Who's Online
There are currently 4710 online users. [Complete List]
» 3 Member(s) | 4707 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)