09-30-2014, 06:53 PM
Thanks Terry,
The thing is, that even with original thinner gauge an extra 15-20 turns would not fit onto the coil's tube.(And I doubt I could make such a gross error). What is happening (I think I did not explain the problem correctly) is that alignment went through just fine at both ends (600 and 1500). But then, the 800 station can be found at 630K.C. on the dial, 1200 station on 1500 and so on with a pointer installed correctly, line to the line. After that all I could do is just rock gang to increase capacity of the J trimmer to raise to pointer closer to the 800, but so far with the trimmer maxed out was able to bring only to 720.
The thing is, that even with original thinner gauge an extra 15-20 turns would not fit onto the coil's tube.(And I doubt I could make such a gross error). What is happening (I think I did not explain the problem correctly) is that alignment went through just fine at both ends (600 and 1500). But then, the 800 station can be found at 630K.C. on the dial, 1200 station on 1500 and so on with a pointer installed correctly, line to the line. After that all I could do is just rock gang to increase capacity of the J trimmer to raise to pointer closer to the 800, but so far with the trimmer maxed out was able to bring only to 720.
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
