1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-2670 cabinet problem
PhilcoJohn
Phorum Expert
*****
Posts: 1,463
Threads: 97
Joined: Jul 2012
City: Poughkeepsie, N.Y.
#10

10-03-2014, 07:25 PM
Wow Ron good job.... did not notice that change in the veneer until you pointed it out. Murf it does not matter and I am sure it will look good! Nice find on the radio. i was interested in one to after looking it up in Rons book!
Find
« Next Oldest | Next Newest »


Messages In This Thread
38-2670 cabinet problem - by murf - 09-27-2014, 03:46 PM
RE: 37-675 cabinet problem - by sam - 09-27-2014, 04:25 PM
RE: 37-675 cabinet problem - by OldRestorer - 09-27-2014, 08:51 PM
RE: 37-675 cabinet problem - by OldRestorer - 09-28-2014, 03:07 PM
RE: 37-675 cabinet problem - by murf - 09-28-2014, 04:19 PM
RE: 38-2670 cabinet problem - by Arran - 09-30-2014, 09:47 PM
RE: 38-2670 cabinet problem - by murf - 10-01-2014, 08:02 PM
RE: 38-2670 cabinet problem - by murf - 10-03-2014, 06:18 PM
RE: 38-2670 cabinet problem - by Ron Ramirez - 10-03-2014, 06:37 PM
RE: 38-2670 cabinet problem - by PhilcoJohn - 10-03-2014, 07:25 PM
RE: 38-2670 cabinet problem - by murf - 10-03-2014, 09:31 PM
RE: 38-2670 cabinet problem - by Arran - 10-04-2014, 11:08 PM
RE: 38-2670 cabinet problem - by Eliot Ness - 10-05-2014, 07:52 AM
RE: 38-2670 cabinet problem - by Arran - 10-07-2014, 11:43 PM
RE: 38-2670 cabinet problem - by murf - 10-08-2014, 01:32 PM
RE: 38-2670 cabinet problem - by thirtiesradio - 10-09-2014, 12:38 AM
RE: 38-2670 cabinet problem - by murf - 10-26-2014, 03:01 PM
RE: 38-2670 cabinet problem - by sam - 10-26-2014, 03:29 PM
RE: 38-2670 cabinet problem - by Eliot Ness - 10-26-2014, 03:36 PM
RE: 38-2670 cabinet problem - by klondike98 - 10-26-2014, 03:46 PM
RE: 38-2670 cabinet problem - by thirtiesradio - 10-26-2014, 10:16 PM
RE: 38-2670 cabinet problem - by jerryhawthorne - 10-27-2014, 02:12 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration