Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

I'm not sure if this is a gain or loss.
#6

Having thought it over for 24 hours and going out in the garage and staring at it every so often. I think what I'll do is see if the coils and transformers managed to survive whatever caused all the rust ( since the outside is not rusty, just dirty with peeling paint...I'm guessing some mice were using it for a double wide trailer). If they're ok, I'll probably give it a go knowing that when I get done it will not look 100% original. I'll try to get it as close as I can without spending 5 times what it will be worth. If the coils and transformers are toast, I'll part it out and look for another. I have several others ahead of this thing on the priority list, so it may take a while. When I was told about this radio a year ago, the lady said "it looks like new as far as I can tell".  I believe a visit to the optometrist is in order. 


Messages In This Thread
RE: I'm not sure if this is a gain or loss. - by Groundhog74 - 10-04-2014, 12:30 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM
Philco 38-7 Speaker
7K should be fine. While not a perfect match (This transformer is meant for 6V6 tubes), Antique Electronic Supply (AES)...MrFixr55 — 08:03 AM
40-150 General questions
I discovered a stamp on the underside of the breadboard on my Philco 40-150. It is"56-1417' in black ink with numbe...Kevin_D — 07:14 AM

[-]
Who's Online
There are currently 2650 online users. [Complete List]
» 1 Member(s) | 2649 Guest(s)
Avatar

>