1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
ZENITH 7S-363 CONSOLE PARTS
Jim Berg
Member
***
Posts: 59
Threads: 2
Joined: Oct 2008
#9

10-30-2008, 10:51 PM
When I have needed to replace the plastic buttons I grind a groove along both sides in line with the arm piece using a Dremel out to the end of the button. I then use wire cutters and break off the old button.
Find
« Next Oldest | Next Newest »


Messages In This Thread
ZENITH 7S-363 CONSOLE PARTS - by philcodave - 10-18-2008, 12:26 AM
Re: ZENITH 7S-363 CONSOLE PARTS - by etech - 10-18-2008, 09:34 AM
Re: ZENITH 7S-363 CONSOLE PARTS - by Ron Ramirez - 10-18-2008, 09:54 AM
Re: ZENITH 7S-363 CONSOLE PARTS - by philcodave - 10-18-2008, 01:47 PM
Re: ZENITH 7S-363 CONSOLE PARTS - by etech - 10-21-2008, 07:31 AM
Re: ZENITH 7S-363 CONSOLE PARTS - by philcodave - 10-21-2008, 07:49 PM
Re: ZENITH 7S-363 CONSOLE PARTS - by etech - 10-21-2008, 08:42 PM
Re: ZENITH 7S-363 CONSOLE PARTS - by Jim Berg - 10-30-2008, 10:51 PM
Re: ZENITH 7S-363 CONSOLE PARTS - by philcodave - 10-31-2008, 01:37 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)