Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Silvertone dial lamps
#5

(10-17-2014, 07:24 PM)Carl Travis Wrote:  Pat,
After looking at a magnified schematic, I believe the dial lamp is a #44.

Thanks Carl,

I'll go with that. But now, I've run into another problem, thanks to an unreadable schematic.

The schematic shows two line-to-ground caps, C45 and C46. However, the chassis has one across-the-line cap, .01 @ 600V. Can I replace that with an X2 safety cap, AND and two .01 Y2 caps as well? Or should I just remove the across-the-line cap and add two line-to-ground caps, as the schematic indicates?

Pat


Messages In This Thread
Silvertone dial lamps - by Patrick - 10-17-2014, 01:39 PM
RE: Silvertone dial lamps - by jerryhawthorne - 10-17-2014, 06:54 PM
RE: Silvertone dial lamps - by Patrick - 10-17-2014, 07:32 PM
RE: Silvertone dial lamps - by Carl Travis - 10-17-2014, 07:24 PM
RE: Silvertone dial lamps - by Patrick - 10-17-2014, 07:41 PM
RE: Silvertone dial lamps - by Radioroslyn - 10-17-2014, 07:57 PM
RE: Silvertone dial lamps - by Patrick - 10-17-2014, 08:21 PM
RE: Silvertone dial lamps - by jerryhawthorne - 10-17-2014, 08:22 PM
RE: Silvertone dial lamps - by Patrick - 10-17-2014, 08:44 PM
RE: Silvertone dial lamps - by Radioroslyn - 10-18-2014, 08:33 AM
RE: Silvertone dial lamps - by Patrick - 10-18-2014, 09:33 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

[-]
Who's Online
There are currently 6905 online users. [Complete List]
» 1 Member(s) | 6904 Guest(s)
Avatar

>