Atwater Kent

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Atwater Kent

morzh
Odobenus rosmarus

Posts: 15,818
Threads: 554
Joined: Oct 2011
City: Jackson, NJ

10-22-2014, 02:42 PM

I just use hot glue gun for that.

If you do not want to crack the insulation (if it hasn't crumbled by itself) - do not desolder anything, bite it off, then solder the new parts.

(This post was last modified: 10-22-2014, 02:43 PM by morzh.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Atwater Kent - by fields 100 - 10-21-2014, 10:51 PM

RE: Atwater Kent - by Jayce - 10-22-2014, 12:13 PM

RE: Atwater Kent - by morzh - 10-22-2014, 02:42 PM

RE: Atwater Kent - by fields 100 - 10-22-2014, 07:53 PM

RE: Atwater Kent - by Arran - 10-23-2014, 02:22 AM

RE: Atwater Kent - by fields 100 - 10-23-2014, 06:39 AM

RE: Atwater Kent - by Arran - 10-24-2014, 09:47 PM

RE: Atwater Kent - by fields 100 - 11-02-2014, 05:34 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 7258 online users. [Complete List]
» 3 Member(s) | 7255 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me