Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dial restoration on a 38-14T
#8

Could not find them either, thanks for the links, Ron.

Well.....will do for initial restoration. Eventually if you come through a better dial, replace it.

I was about to say you can use "38-15" dial but the SW part is different on it so, no.


Messages In This Thread
Dial restoration on a 38-14T - by varrojames - 10-22-2014, 01:59 PM
RE: Dial restoration on a 38-14T - by Eliot Ness - 10-22-2014, 03:18 PM
RE: Dial restoration on a 38-14T - by Ron Ramirez - 10-22-2014, 09:32 PM
RE: Dial restoration on a 38-14T - by Arran - 10-22-2014, 09:50 PM
RE: Dial restoration on a 38-14T - by morzh - 10-23-2014, 11:03 AM
RE: Dial restoration on a 38-14T - by Steve D - 10-24-2014, 08:56 AM
RE: Dial restoration on a 38-14T - by Ron Ramirez - 10-24-2014, 10:11 AM
RE: Dial restoration on a 38-14T - by morzh - 10-24-2014, 10:18 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>