Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Next case - Odd Philco 42-720 Tropic
#30

Oh, it was the power transformer, alright. You should have seen the smoke coming off that sucker...And it is HOT HOT HOT. The wax inside the transformer melted and was coming out.

I think when the Brand Z 6X5 shorted out, the damage was done. Then I come along, buy the set and try to get it going again...My guess is that the 6X5 short caused windings in the power tranny to partially short, and it couldn't handle the stress of normal usage after I put in the good 6X5 tube.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
RE: Next case - Odd Philco 42-720 Tropic - by Ron Ramirez - 10-28-2014, 05:26 PM
RE: Next case - Odd Philco 42-720 Tropic - by sam - 10-30-2014, 03:55 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM
Restoring Philco 96
I have eventually replaced the speaker and shot the video, which only shows the upper part of the dial as the hum is ver...morzh — 09:24 PM
Rogers Majestic R-646
Kinda weird to see both open Nothing weird if you remember that this radio is about 100 years old  :)Vlad95 — 07:49 PM
Philco 42-345 Restoration/Repair
I believe I'm making progress, resistors have been rechecked and corrected, removed that ugly blue capacitor and more wi...osanders0311 — 07:38 PM
Philco Model 16 wiring question
Thanks Morzh Yes I recapped everything and replaced almost all the resistors as well. I redid #99 with .015 safety ca...bobclausen — 07:11 PM
Philco Model 16 wiring question
Well...pull out every single load of the transformer. For every winding. Unsolder if needed. Then re-do your dim bulb....morzh — 07:02 PM

[-]
Who's Online
There are currently 1321 online users. [Complete List]
» 1 Member(s) | 1320 Guest(s)
Avatar

>