Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Atwater Kent 206
#3

Only 1 picture, but, from that, I would 'let it be" too.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
Atwater Kent 206 - by fields 100 - 11-02-2014, 10:29 AM
RE: Atwater Kent 206 - by Ron Ramirez - 11-02-2014, 10:38 AM
RE: Atwater Kent 206 - by Phlogiston - 11-02-2014, 12:15 PM
RE: Atwater Kent 206 - by Mondial - 11-02-2014, 01:12 PM
RE: Atwater Kent 206 - by Eliot Ness - 11-02-2014, 02:31 PM
RE: Atwater Kent 206 - by morzh - 11-02-2014, 03:53 PM
RE: Atwater Kent 206 - by fields 100 - 11-02-2014, 05:24 PM
RE: Atwater Kent 206 - by Arran - 11-03-2014, 01:39 AM
RE: Atwater Kent 206 - by fields 100 - 11-07-2014, 07:29 PM
RE: Atwater Kent 206 - by thirtiesradio - 11-03-2014, 03:18 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 5230 online users. [Complete List]
» 2 Member(s) | 5228 Guest(s)
AvatarAvatar

>