Atwater Kent

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Atwater Kent

fields 100
Member

Posts: 228
Threads: 64
Joined: Dec 2013
City: Northbrook, IL

11-02-2014, 05:34 PM

There is a .01uF line capacitor in the right bottom corner of the picture, next to that big paper e-cap. Looking from the top it is rectangular black piece with a fastener nut in the middle. It is not paper type, made out of some plates with insulators between. Since this photo was taken, I completely rewired it and trying to keep it as original as possible, hence my question- should I still put Y type, or keep the original one?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Atwater Kent - by fields 100 - 10-21-2014, 10:51 PM

RE: Atwater Kent - by Jayce - 10-22-2014, 12:13 PM

RE: Atwater Kent - by morzh - 10-22-2014, 02:42 PM

RE: Atwater Kent - by fields 100 - 10-22-2014, 07:53 PM

RE: Atwater Kent - by Arran - 10-23-2014, 02:22 AM

RE: Atwater Kent - by fields 100 - 10-23-2014, 06:39 AM

RE: Atwater Kent - by Arran - 10-24-2014, 09:47 PM

RE: Atwater Kent - by fields 100 - 11-02-2014, 05:34 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

Who's Online

There are currently 5206 online users. [Complete List]
» 1 Member(s) | 5205 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me