11-07-2014, 05:39 PM
I was under the impression that you can always go a bit higher in the capacitance value (i.e - replace a 40uf cap with a 47 uf cap), but NEVER should you go lower? Is that wrong?
Philco 53-566 multi-cap
« Next Oldest | Next Newest »
Messages In This Thread
Philco 53-566 multi-cap - by Art Hoch - 11-07-2014, 12:21 AM
RE: Philco 53-566 multi-cap - by Art Hoch - 11-07-2014, 12:23 AM
RE: Philco 53-566 multi-cap - by morzh - 11-07-2014, 12:26 AM
RE: Philco 53-566 multi-cap - by Arran - 11-07-2014, 01:48 AM
RE: Philco 53-566 multi-cap - by Mondial - 11-07-2014, 08:41 AM
RE: Philco 53-566 multi-cap - by morzh - 11-07-2014, 10:32 AM
RE: Philco 53-566 multi-cap - by Art Hoch - 11-07-2014, 01:16 PM
RE: Philco 53-566 multi-cap - by ODPILOT - 11-07-2014, 05:39 PM
RE: Philco 53-566 multi-cap - by Eric Adams - 11-07-2014, 05:53 PM
RE: Philco 53-566 multi-cap - by Arran - 11-08-2014, 04:56 AM
RE: Philco 53-566 multi-cap - by Art Hoch - 11-08-2014, 12:43 PM
RE: Philco 53-566 multi-cap - by David - 11-08-2014, 06:30 PM
Users browsing this thread: 1 Guest(s) |
|